Lund 67500 Toaster 700-850 W, 2 Slices, 7 Browning Levels, Defrost, Reheat

The Lund 67500 is a classic two-slice toaster for heating, toasting and defrosting sliced bread. A 7-stage browning control and three function buttons – DEFROST, REHEAT and CANCEL – let you handle fresh and frozen bread alike. Guides inside the slots keep the bread at the same distance from the heaters, so both sides are toasted with the same intensity at the same time. When toasting finishes the toaster stops and lifts the bread automatically.

Connecting to the mains

Connect the toaster directly to a single wall socket. Extension cords, adapters and double sockets are forbidden. The supply circuit must be fitted with a protective conductor and at least a 16 A protective device.

• Check that the mains voltage and frequency match the rating plate. Modifying the plug or the socket is forbidden.
• Keep the cord away from sharp edges and hot surfaces. The cord must be fully unwound during operation and must not create a tripping hazard.
• The socket must remain easily accessible. Always pull the plug by its housing, never by the cord.
• If the cord or the plug is damaged, disconnect the appliance immediately and contact an authorised service centre. The cord and the plug cannot be repaired – they must be replaced.

Placement

• Place the toaster on a hard, flat, level, non-flammable surface resistant to high temperatures and able to carry its weight.
• Leave at least 10 cm of free space around the side walls for ventilation, and do not put materials that are not heat-resistant above the appliance.
• Do not place the toaster near flammable materials such as curtains or drapes.
• Do not place any electrical equipment above the toaster – the water vapour released during operation can cause a short circuit and electric shock.
• Move the appliance only when it has cooled down, grasping the housing – never by pulling the cord.

How to use

1. Unpack the toaster and remove all packaging. It is worth keeping the packaging for transport and storage.
2. Clean the appliance as described under Cleaning and care before the first use.
3. Make sure the cord is fully unwound from the housing – do not use the toaster with the cord wound at the bottom.
4. Set the browning level with the knob. For the first use, set the knob in the middle of the scale and adjust it afterwards.
5. Put the bread into at least one toast slot and plug the toaster in.
6. Press the push-down lever all the way down. If it stays in the lower position after you release it, toasting starts; the toaster stops and lifts the bread automatically. You can interrupt toasting at any time with CANCEL.
7. REHEAT warms up an already toasted slice without increasing the browning level. Press REHEAT – the button lights up; the toaster stops and lifts the bread when it finishes.
8. DEFROST defrosts and toasts the bread. Press DEFROST – the button lights up; the toaster stops and lifts the bread when it finishes.
9. Unplug the toaster after use and let it cool completely. Do not store the appliance plugged into a socket.

Important — safety

• During and immediately after operation the housing and the metal parts heat up to a high temperature – contact can cause serious burns.
• BREAD MAY BURN. Observe the bread at all times and keep the toaster under supervision while it is operating – bread left unattended can burn and cause a fire and serious burns.
• The toaster is intended only for sliced bread without additives and must not be used to prepare any other food. Bread intended for toaster preparation is recommended.
• Do not put too thick bread slices into the toaster – contact of the bread with the heater may lead to fire.
• Never place bread or other products on top of the toast slots. Covering the top causes overheating, which can damage the toaster and cause fire and/or electric shock.
• If the bread gets stuck, do not remove it with your hands or metal tools. Unplug the toaster, let it and the bread cool down completely, then carefully remove the bread using your hands or wooden tools, taking care not to damage or deform the toaster components.
• Empty the crumb tray as often as this manual specifies.
• It is forbidden to repair, disassemble or modify the appliance on your own – all repairs must be carried out by an authorised service centre. Drilling holes or making any other modifications is forbidden.
• The appliance is not intended for use by children under 8 years of age or by persons with reduced physical, sensory or mental abilities unless they are supervised or instructed on safe use and understand the risks involved. Children must not play with the appliance, and unattended children must not clean or maintain it.
• The product is for household use only. It must not be used in commercial applications, e.g. in catering facilities.
• Indoor use only. Do not expose the appliance to precipitation or water in any form. Make sure the floor near the place of use is not slippery.

Cleaning and care

Switch the appliance off, unplug it and let all parts cool down completely before cleaning. NEVER immerse the toaster in water or any other liquid, and never clean it under running water, with a high-pressure water jet or in a dishwasher.

• There is an extendible crumb tray at the bottom of the housing. Remove and clean it after every use. Wash the tray under running water with a small amount of dishwashing liquid, dry it and slide it back into its slot. Do not clean the crumb tray in a dishwasher or with a high-pressure water jet.
• Clean the housing with a soft, slightly damp cloth and then wipe it dry.
• Clean the inside by turning the toaster upside down with the slots downwards and shaking out the crumbs.
• Do not use abrasive or caustic agents, alcohol, solvents or similar cleaners.

Storage and transport

• The power cord can be wound in the lower housing for storage.
• Store the toaster indoors, protected from dust, dirt and moisture, in its original packaging and in the operating position. Do not stack the products in layers and do not place anything on the appliance.
• Transport the product in its original packaging and protect it against excessive shocks.

Compliance and disposal

• The appliance complies with Directives 2014/35/EU (LVD), 2014/30/EU (EMC) and 2011/65/EU (RoHS) and carries the CE mark. Parts in contact with food are covered by Regulation (EC) 1935/2004, and Regulation (EU) 2023/988 on general product safety also applies.
• WEEE (2012/19/EU): do not dispose of the appliance with household waste — take it to an electrical and electronic waste collection point or return it to the seller.
• Sort the packaging: cardboard and paper to paper collection, film to plastic collection.

Manufacturer and distributor

• Manufacturer: TOYA S.A., ul. Soltysowicka 13-15, 51-168 Wroclaw, Poland, tel. +48 71 32 41 400, toya@toya.pl
• Distributor: BSC Vilnius, UAB, Kareiviu g. 19, Vilnius 09133, Lithuania. Tel. +370 637 09990. www.fit2.shop, info@fit2.shop